Inkochnito Flipperkast voeding pcb

45,00 excl. btw

In Stock
This item is low in stock.

Item(s) left: 0

Heb je een vraag? Mail ons

info@shipelektro.nl Stel ons een vraag via e-mail

Lage prijzen

Goede prijs voor goede kwaliteit

Experts in elektronica

Wij bieden deskundig advies

GRATIS thuisbezorgd

Gratis verzending vanaf 130 euro

Beschrijving

English below.

 

Behalve producten voor de binnenvaart kunnen wij ook andere producten maken op aanvraag. De printplaat “inkochnito” voor de voeding van de Williams flipperkast is hier een voorbeeld van.

In divers flipperkasten van Williams is een ontwerpprobleem. Het gaat hier om het missen van de zekeringen voor de brugcellen van de 18V voor de gestuurde lampen en de 34V voor de spoelen. Door het missen van de zekeringen kan het heel erg fout gaan in een flipperkast. Zodra er in een brugcel kortsluiting ontstaat, bestaat de mogelijkheid dat de bedrading vanaf de trafo naar de brugcellen verbrand. In het ergste geval gaat ook de trafo in rook op. En in het gunstigste geval gaat de hoofdzekering van de kast eruit.

Om dit probleem te ondervangen wordt geadviseerd een zekering in het circuit te plaatsen voor de brugcellen. Een simpele oplossing die goed te doen is. Een ander bijkomend probleem is de leeftijd van de hele grote condensator in het 18V circuit. De levensduur van zo’n condensator is in het algemeen 10 tot 15 jaar. Een leeftijd die bij alle kasten al ruim overschreden is. Nu is dat voor de gestuurde lampen niet zo heel erg, maar het kan voor de sturing wel problemen opleveren. Als dan ook nog de gestuurde lampen wat minder fel branden, dan kan het zijn dat er ook nog een brugcel defect is. Al deze problemen zijn ondervangen met deze print.

Makkelijk vast te zetten d.m.v. schroeven, en zonder te solderen.

Meer informatie over het gebruik in een flipperkast is te vinden op https://home.kpn.nl/p.koch3/bridge_board.htm

———————————————————————————

In addition to products for inland shipping, we can also make other products on request. The circuit board “inkochnito” for the power supply of the Williams pinball machine is an example of this.

There is a design problem in several Williams pinball machines. This is about missing the fuses for the bridge cells of the 18V for the controlled lamps and the 34V for the coils. If the fuses are missing, things can go very wrong in a pinball machine. As soon as a short circuit occurs in a bridge cell, there is a possibility that the wiring from the transformer to the bridge cells will burn. In the worst case, the transformer will also go up in smoke. And in the best case scenario, the main fuse of the cabinet will blow.

To overcome this problem it is recommended to place a fuse in the circuit before the bridge cells. A simple solution that works well. Another additional problem is the age of the very large capacitor in the 18V circuit. The life of such a capacitor is generally 10 to 15 years. An age that has already been well exceeded in all cabinets. Now that is not so bad for the controlled lamps, but it can cause problems for the control. If the controlled lamps also burn less brightly, it is possible that a bridge cell is also defective. All these problems have been solved with this print.

Simple screw connections, no soldering skills needed.

More information about using it in a pinball machine can be found at https://home.kpn.nl/p.koch3/bridge_board.htm

Extra informatie

Gewicht1 kg